1, clean up the seam

In the use of the United States before the slit, the first to clean up the utility knife, and then draw the edge of the two sides of the brick, and then raised the middle of the place clean, and then with a brown hair brush with wet sponge, the dust can clean up . It is worth noting that the dirty here, we must deal with clean, or the next step will not be implemented.

2, the installation of glue gun

And then use the discharge nozzle to open the sealant seam, then install the nozzle, and then the mouth of the mouth made of 45 degrees to the angle, you can press the glue gun back pressure plate, open the plastic gun rod, Into the US seam agent on it.

3, playing the United States seam agent

First, the United States and even slit into the cracks in the tile, and then hand to smooth, slightly with point force, this will make the seam agent is not parallel to the ground, can effectively reduce the wear degree.

4, wet sponge cleaning

And then wipe the sponge with a wet sponge, remember to wipe, you must pay attention to the control of its strength, if the force is too large, it will erase the cracks inside the seam agent. If the force is too small, will not clean, affecting its appearance. After wiping, and finally in the quick-drying of the United States to clean up a sewing agent to ensure that the treatment can be clean. Well, these are the steps on the use of ceramic tile joints which related content, and we are not already use it? If you want to know more about the US plastic information, please continue to focus on ANDME and the United States seam.